User Manual

- 6 -
To remove the INJ-24 from the
DIN
-Rail, insert a flat-blade screw
driver horizontally into the DIN
-
Rail
kit under the
INJ-
24, and then pull it
upwards and release
INJ-
24 towards
you away from the DIN
-Rail.
You may also take the following steps t
o remove the INJ-24 from the
DIN-Rail.
Step 1
:
P
ress the middle of the flat side of
the mounting kit as indicated
. Pull
the INJ-24 downwards.
Step 2:
R
elease it towards you and away
from the DIN
-Rail.
Grounding the INJ-24
Grounding and wire routing help limit the
effects
of noise due to electromagnetic
interference (EMI). Run the right most contact
of the 3
-
contact terminal block to the grounding
surface prior to connecting devices.
ATTENTION
This product is intended to be mounted to a wel
l-grounded
mounting surface, such as a metal panel.