User Manual

- 2 -
Overview
The Moxa PoE Injector INJ-24 Series is a 1-port PoE injector that
delivers both data and electrical power to Ethernet-enabled devices using
a single Ethernet cable. The INJ-24 can supply up to 30 watts of power
through the Ethernet port, and can power IEEE 802.3af/at compliant
powered devices (PD), such as wireless access points or IP cameras,
eliminating the need for additional wiring. The INJ-24 supports Gigabit
communication, which is vital for high-speed and low-latency applications.
The INJ-24 also offers a wide operating temperature range of -40 to 75°C,
and is designed to withstand a high degree of vibration and shock. A
rugged hardware design makes the INJ-24 perfect for ensuring that your
Ethernet equipment can operate in critical industrial environments, such
as in hazardous locations, and complies with FCC and CE standards.
Wiring Requirements
WARNING
Do not disconnect modules or wires unless the power supply has
been switched off or the area is known to be non
-
hazardous. The
devices may only be connected to the supply voltage shown on
the type plate. The devices are designed for operation
with a
Safety Extra
-
Low Voltage. Thus, they may only be connected to
the supply voltage connections and to the signal contact with the
Safety Extra
-Low Voltages (SELV) in compliance with IEC
60950-1/EN 60950-1.
WARNING
The power for this product is intended to be supplied by a Listed
Power Unit, with output marked LPS, and rated to deliver 24 DC
at a maximum of 1.3 A.
WARNING
This unit is a built
-in type. When the unit is installed in a
nother
piece of equipment, the equipment enclosing the unit must
comply with fire enclosure regulation IEC 60950
-1/EN60950-1
(or similar regulation).