User`s manual

IKS-6726 Gettying Started
2-5
NOTE To connect to the IKS-6726’s Telnet or web console, your PC host and the IKS-6726 must be on the same
logical subnet.
NOTE When connecting to the IKS-6726’s Telnet or web console, first connect one of IKS-6726’s Ethernet ports to
your Ethernet LAN or directly to your PC’s Ethernet port. You may use either a straight-through or cross-ove
r
Ethernet cable.
NOTE The IKS-6726’s default IP address is 192.168.127.253.
After making sure that the IKS-6726 is connected to the same LAN and logical subnet as your PC, open the
IKS-6726’s Telnet console as follows:
1. Click Start  Run from the Windows Start menu. Telnet to the IKS-6726’s IP address from the Windows
Run window. You may also issue the Telnet command from a DOS prompt.
2. In the terminal window, the Telnet console will prompt you to select a terminal type. Type 1 to choose
ansi/vt100, and then press Enter.
3. The Telnet console will prompt you to log in. Press Enter and select admin or user. Use the down arrow
key on your keyboard to select the Password field and enter a password if desired. This password will be
required to access any of the consoles (web, serial, Telnet). If you do not wish to create a password, leave
the Password field blank and press Enter.