User`s manual

IA260 WinCE User’s Manual Getting Started
From any command window (telnet or console), type the “netshare -h” command to display the
following command syntax:
Configuring the FIFO
You can enable or disable the FIFO with the utility’s “setfifo” command. For example, type
“setfifo COM1: 0” to disable the FIFO of COM1, or type “setfifo COM1: 1” to enable the FIFO of
COM1. Note that you can check the FIFO status by typing “setfifo”.
\ >setfifo COM1: 0
Set FIFO success
\> setfifo
COM1: FIFO = Disabled
COM2: FIFO = Enabled
COM3: FIFO = Enabled
COM4: FIFO = Enabled
2-14