Installation Guide

- 8 -
W irin g t he Re dunda n t Pow e r I n put s
The EDS device includes both high - volt age and low - volt age pr oduct s.
For t he low- volt age ( LV m odels) product s, t here are t wo power input s
for r edundancy ; for t he high- volt age ( HV m odels) product s, there is
only one pow er input. Refer t o t he inst ructions and diagram below on
how t o connect t he w ires t o the t erm inal block connect or on the
recept or.
STEP 1 : I nsert t he Posit ive/ Negat ive
DC
or Line/ Neutr al AC wires int o t he
V
+ / V- or L/ N t erm inals, respectively.
STEP 2 :
To keep t he DC or AC w ires
fr om pulling loose, use a sm all flat
-
blade scr ew dr iver t o t ight en t he wire
-
clam p screw s on t he front of t he
t erm inal block connect or.
STEP 3 :
I nser t t he plast ic ter m inal
bloc
k connect or pron gs int o t he
ter m inal block recept or, w hich is
locat ed on t he EDS devices’ right side.
W irin g t he Digit a l I nput s
The EDS device has one set of digit al input (DI ) . The DI consist s of t wo
con tact s of t he 4- pin ter m inal block connector on the EDS's right - side
panel. Refer t o the inst ruct ions and diagram below on how t o connect
the w ires t o the ter m inal block connect or on t he receptor.