Installation Guide

- 6 -
W irin g Re quir e m e n t s
ATTEN TI ON
Sa fe t y Fir st !
Ext ernal m etal part s are hot . Take
the necessar y pr ecaut ion s if
you are r equired t o handle t he device.
ATTEN TI ON
I n order t o ensure reliable oper at ions, please m ake sure the
operat ing t em perat ur e of t he en vironm ent does not exceed t he
specificat ions. When m ount ing an EDS device wit h ot her
operat ing unit s in a cabinet w it hout forced vent ilation, a
m in im u m of
4 cm spac
e on bot h t he left and right of t he sw it ch
is recom m ended.
ATTEN TI ON
Sa fe t y Fir st !
Be sure t o disconnect the power cord before in stalling and/ or
wiring your EDS device. Calculat e t he m axim u m possible
current in each
pow er w ire and com m on w ire. Obser ve all
elect rical codes dict ating the m axim um current allow able for
each wir e size. I f t he current goes above t he m axim um rat ings,
the w iring could overheat , causing ser ious dam age to your
equipm ent .
Be sur e to read and follow t hese im por t ant point s below :
• Use separat e pat hs t o rout e wir ing for pow er and devices. I f pow er
wiring and device w iring pat hs m ust cr oss, m ake sure t he wires are
per pendicular at the intersect ion point.
N OTE
Do not run signal or com m unications w iring an d power w iring
thr ough t he sam e w ire conduit . To avoid inter ference, w ires
with different signal char act erist ics should be rout ed separ ately.
• You can use t he t ype of signal tr ansm it t ed t hrough a w ire t o
det erm ine which wires should be k ept separate. The rule of t hum b
is t hat wir ing t hat shares sim ilar elect rical charact erist ics can be
bundled t oget her.
• You should separat e input w iring from out put wiring.
• We advise t hat you label t he w iring to all devices in y our syst em .