Installation Guide

- 5 -
W a ll Mount ing ( Opt iona l)
For som e applications, y ou will fin d it convenient to m ount t he Moxa
EDS device on a w all, as show n in the following illust rations:
STEP 1 —Rem ove t he DI N- rail
at tachm ent pl
at e fr om t he rear
panel of t he EDS device,
as
illust rat ed
in the diagram on
the
r ight .
STEP 2 —Mounting t he EDS device on a w all
requires
six screws. Use t he EDS device, with w all
m ount plat es at t ached, as a guide t o m ark t he
cor rect locat ions of t he
six scr ew s. T
he heads of t he
screws sh ould be less t han 6.0 m m in diam et er ,
and t he shaft s should be less t han 3.5
m m in
diam et er, as sh own in t he figure on at r ight .
N OTE
Befor e t ightening t he screws int o t he wall, m ake sure t he scr ew
head and shank size are suit able by insert ing t he screw t hrough
one of the keyhole
-shaped apert ures of t he Wall Mount ing
Plates.
N OTE
Do not scr ew t he screw s in all t he w ay—leave about 2 m m t o
allow room for sliding t he wall m ount panel between t he wall
and t he scr ew s.
STEP 3 —Once t he scr ew s ar e
fixed
to the w all, insert t he
four scr ew heads t hrough the
wide part s of the keyhole
-
shaped aper tures, and then
slide
the EDS device
dow nwards, as indicat ed
in
the figure
at the right .
Tighten t he four screw s for
m or e
st abilit y.