User Manual

- 11 -
DIP Switch
Setting
Description
BSP
ON
Enables broadcast storm protection
OFF
Disables broadcast storm protection
Jumbo Frame
ON
Enables jumbo frame function
OFF
Disables jumbo frame function
802.3az
ON
Enables the energy-efficient Ethernet function
OFF
Disables the energy-efficient Ethernet function
Port Alarm
ON
Enables the corresponding PORT Alarm. If the
port’s link fails, the relay will form an open
circuit and the fault LED will light up
OFF
Disables the corresponding PORT Alarm. If the
port’s link fails, the relay will form a closed
circuit and the fault LED will never light up
ATTENTION
To actively update DIP switch settings, power off and then power
on the EDS.
LED Indicators
The front panel of the Moxa EtherDevice Switch contains several LED
indicators. The function of each LED is described in the table below.
LED
Color
State
Description
PWR1 AMBER
On
Power is being supplied to power input
PWR1
Off
Power is not being supplied to power
input PWR1
PWR2 AMBER
On
Power is being supplied to power input
PWR2
Off
Power is not being supplied to power
input PWR2
FAULT RED
On
When the corresponding PORT alarm is
enabled, and the port’s link is inactive.
Off
When the corresponding PORT alarm is
enabled and the
port’s link is active, or
when the corresponding PORT alarm is
disabled.
10/100M
(TP port)
AMBER
On
TP port’s 10/100 Mbps link is active.
Blinking
Data is being transmitted at 10/100
Mbps.
Off
TP Port’s 10/100 Mbps link is inactive.
1000M
(TP port)
GREEN
On
TP port’s 1000 Mbps link is active.
Blinking
Data is being transmitted at 1000
Mbps.
Off
TP Port’s 1000 Mbps link is inactive.
100/1000M
(SFP port)
AMBER
On
SFP port’s 100 Mbps link is active.
Blinking
Data is being transmitted at 100 Mbps.
Off
SFP port 100 Mbps link is inactive.
GREEN
On
SFP port’s 1000 Mbps link is active.
Blinking
Data is being transmitted at 1000
Mbps.
Off
SFP port’s 1000 Mbps link is inactive.