User`s manual

Communication Redundancy Turbo Ring
2-11
NOTE The Turbo Ring DIP Switches located on the outer casing of EDS series switches
can be used to configure the
switches’ Turbo Ring protocols.
If you use the web interface, console interface, or Telnet interface to enable the
Turbo Ring DIP Switches, and
then set DIP Switch 4 on the switch’s outer casing to the ON position, you will not be able to use the web
interface, console interface, or Telnet interface to change the status of the DIP Switch. In this case, the
Communication Redundancy settings will be grayed out in the web browser as shown in the following figure: