Installation Guide

- 12 -
ATTEN TI ON
This is a Class 1 Laser/ LED pr oduct . To avoid causing ser ious
dam age to your eyes, do not st are direct ly into t he Laser Beam .
Rese t But t on
There are t wo funct ions available on t he Reset But t on. One is t o r eset
the Ethernet swit ch to fact or y default set tings by pressing and holding
the Reset but t on for 5 seconds. Use a point ed obj ect , such as a
st raight ened paper clip or t oothpick , t o depress t he Reset but t on. This
will cause the STATE LED t o blink once a second. After depr essing t he
but ton for 5 cont inuous seconds, t he STATE LED will st art t o blink
rapidly. This indicat es that fact ory default set tings have been loaded
and you can r elease t he reset but t on. The ot her funct ion is t o reboot
the device by depressing the reset but ton for less than five seconds.
Tur b o Ring DI P Sw it ch Set t in gs
The EDS devices are plug- and- play m anaged redundant Ethernet
sw it ches. The propr iet ar y Turbo Ring prot ocol was developed by Moxa
to pr ovide bet t er net work r eliabilit y and fast er recovery t im e. Mox a
Turbo Ring’s recover y t im e is less t han 50 m s ( Turb o Ring V2 ) —
com pared t o a 3- t o 5- m inut e recovery t im e for com m er cial swit ches—
decreasing t he possible loss caused by net work failur es in an indust rial
set t ing.
Ther e ar e five Hardware DI P Switches for Turbo Rin g on t he bott om
panel of t he EDS device t hat can help setup t he Turbo Ring easily
within seconds. I f you do not want t o use a hardw are DI P swit ch t o
set up t he Turbo Ring, y ou can use a web browser, t elnet , or console t o
disable this funct ion.
N OTE
Please refer t o t he Tur bo Rin g
sect ion in User's Man ual for
m ore det ail informat ion about t he set ting and usage of
Tu rbo
Rin g V2 .
Turbo Ring D I P Sw itch Se t t ings
The default setting for each DI P Sw it ch is OFF. The
follow ing t able explains t he effect of set ting t he DI P
Sw it ch to t he ON posit ion
.
Rem ove t he rubber cover on t he bottom panel of
the device
t o expose t he DI P switches.