Installation Guide

- 7 -
ATTENTION
When installing or removing the device, please insert a flat
-
head screwdriver into the latch of the holding clamp and pull
the latch downward rather than push
ing it towards the DIN rail
side,
when removing the module from the rail.
If you want to change the position
of the device
on the DIN rail,
please follow the
steps shown in the images above. First,
remove the device
using a flat-head screwdriver and then re-
install
the device in the desired
position. Please DO NOT directly
move the device on the DIN rail
without uninstalling it first.
If the equipment is used in a manner not specified by the
manufac
turer, the protection provided by the equipment may
be impaired.
Please us
e a flat-head screwdriver
with a
head size of between 4 and 6
mm
for proper installation or
removal.
NOTE
1.
The installation and the safety of any system incorporating
the equipment is the responsibility of the assembler of the
system.
2.
This is an OPEN TYPE module and should be installed in a
safety enclosure with mechanical rigidity and an
appropriate IP rating.