User`s manual

EDR-G903/G902 Features and Functions
3-59
1. Configure Email Event Types
Select the desired Event types from the Web Browser Event type page (a description of each event type is
given later in the Email Alarm Events setting subsection).
2. Configure Email Settings
To configure the EtherDevice Router’s email setup from a browser interface, enter your Mail Server’s IP/Name
(IP address or name), Account Name, Account Password, the sender’s email address, and the email address to
which warning messages will be sent.
3. Activate your settings and if necessary, test the email
After configuring and activating your EtherDevice Router’s Event Types and Email Setup, you can use the Test
Email function to see if your e-mail addresses and mail server address have been properly configured.
Event Type
Email Warning Event Types can be divided into two basic groups: System Events and Port Events. System
Events are related to the overall function of the router, whereas Port Events are related to the activity of a
specific port.
System Events Warning email is sent when…
Cold Start Power is cut off and then reconnected.
Warm Start The EtherDevice Router is rebooted, such as when network parameters are
changed (IP address, subnet mask, etc.).
Power Transition (On-Off) The EtherDevice Router is powered down.
Power Transition (Off-On) The EtherDevice Router is powered up.
DI (Off) Digital Input is triggered by on to off transition
DI (On) Digital Input is triggered by off to on transition
Config. Change A configuration item has been changed.
Auth. Failure An incorrect password is entered.
Port Events Warning email is sent when…
Link-ON The port is connected to another device.
Link-OFF The port is disconnected (e.g., the cable is pulled out or the opposing device
shuts down).