User`s manual

EDR-G903/G902 Features and Functions
3-36
EtherType
Setting Description Factory Default
0x0600 to 0xFFFF When Protocol is set to “Manual” you can set up EtherType
manually
None
Target
Setting Description Factory Default
Accept The packet will pass the Firewall when it matches this Firewall
policy
None
Drop The packet will not pass the Firewall when it matches this
Firewall policy
None
Source MAC Address
Setting Description Factory Default
Mac Address This Firewall Policy will check all Source MAC addresses of the
packet
00:00:00:00:00:00
Destination MAC Address
Setting Description Factory Default
Mac Address This Firewall Policy will check all destination MAC addresses of
the packet
00:00:00:00:00:00
The following table shows the Layer 2 protocol types commonly used in Ethernet frames.
EtherType for Layer 2 Protocol
Type Layer 2 Protocol
0x0800 IPv4 (Internet Protocol version 4)
0x0805 X.25
0x0806 ARP (Address Resolution Protocol)
0x0808 Frame Relay ARP
0x08FF G8BPQ AX.25 Ethernet Packet
0x6000 DEC Assigned proto
0x6001 DEC DNA Dump/Load
0x6002 DEC DNA Remote Console
0x6003 DEC DNA Routing
0x6004 DEC LAT
0x6005 DEC Diagnostics
0x6006 DEC Customer use
0x6007 DEC Systems Comms Arch
0x6558 Trans Ether Bridging
0x6559 Raw Frame Relay
0x80F3 Appletalk AARP
0x809B Appletalk
0x8100 8021Q VLAN tagged frame
0x8137 Novell IPX
0x8191 NetBEUI
0x86DD IPv6 (Internet Protocol version 6)
0x880B PPP
0x884C MultiProtocol over ATM
0x8863 PPPoE discovery messages
0x8864 PPPoE session messages
0x8884 Frame-based ATM Transport over Ethernet
0x9000 Loopback