User`s manual

EDR-G903/G902 Features and Functions
3-34
Firewall Policy Configuration
The EtherDevice Router’s Firewall policy provides secure traffic control, allowing users to control network traffic
based on the following parameters.
Interface From/To
Setting Description Factory Default
All (WAN1/WAN2/LAN) Select the From Interface and To interface From All to All
WAN1
WAN2
LAN
Quick Automation Profile
Setting Description Factory Default
Refer to the “Quick
Automation Profile”
section on page 3-29.
Select the Protocol parameters in this Firewall Policy None
Service
Setting Description Factory Default
IP Filter This Firewall policy will filter by IP address IP Filter
MAC Filter This Firewall policy will filter by MAC address
Target
Setting Description Factory Default
Accept The packet will penetrate the firewall when it matches this
firewall policy
Accept
Drop The packet will not penetrate the firewall when it matches this
firewall policy
Source IP
Setting Description Factory Default
All (IP Address) This Firewall Policy will check all Source IP addresses in the
packet
All
Single (IP Address) This Firewall Policy will check single Source IP addresses in the
packet
Range (IP Address) This Firewall Policy will check multiple Source IP addresses in
the packet
Source Port
Setting Description Factory Default
All (Port number) This Firewall Policy will check all Source port numbers in the
packet
All
Single (Port number) This Firewall Policy will check single Source Port numbers in the
packet
Range (Port number) This Firewall Policy will check multiple Source port numbers in
the packet