User`s manual

EDR-G903/G902 Features and Functions
3-27
Clickable Buttons
Add
For adding an entry to the Static Routing Table.
Delete
For removing selected entries from the Static Routing Table.
Modify
For modifying the content of a selected entry in the Static Routing Table.
NOTE
The entries in the Static Routing Table will not be added to the EtherDevice Router’
s routing table until you
click the Activate button.
RIP (Routing Information Protocol)
RIP is a distance-vector routing protocol that employs the hop count as a routing metric. RIP prevents routing
loops by implementing a limit on the number of hops allowed in a path from the source to a destination.
The RIP page is used to set up the RIP parameters.
RIP State
Setting Description Factory Default
Enable/Disable Enable or Disable RIP protocol Disable
Enable WAN 1 RIP
Check the checkbox to enable RIP in the WAN 1 interface.
Enable WAN 2 RIP
Check the checkbox to enable RIP in the WAN 2 interface.
Enable LAN RIP
Check the checkbox to enable RIP in the LAN interface.
RIP V1 only
Check the checkbox to enable only RIP V1 interfaces.
Redistributed Static Router
Check the checkbox to enable the Redistributed Static Route function. The entries that are set in a static route
will be re-distributed if this option is enabled.