User`s manual

PCI Express Board User’s Manual Software Installation
3-50
5. After rebooting computer, key in “moxaadm”, you will see MAIN MENU, select Basic
Configuration.
MAIN MENU
Basic Configuration
Advanced Configuration
Interface Configuration
Port Monitoring
Terminal Emulation
Driver Removal
Exit
6. You will see the following screen. Press Enter to select the MOXA Multiport Serial Board
you installed by port and by model. For example, if you installed the CP-104EL, select 4 ports
and then CP-104EL.
MOXA Smartio/Industio Family Installation Utility (Ver 1.11)
Smartio/Industio Family Basic Configuration
Board No. Board Type I/O Address Interrupt Bus/Dev No.
1 None ------------ ------------ ------------
2 None ------------ ------------ ------------
3 None ------------ ------------ ------------
4 None ------------ ------------ ------------
PgDn: getty Setting
Enter: Confirm Input Value
Esc: Exit
Tab: Change Item
7. The board’s basic information, such as I/O address, Bus No., and Device No., will be shown.
The SCO system will assign the resources automatically to the PCI Express board you
selected.
8. Next, press “Esc” to exit and reboot your computer.
9. <Note: The step 9 & 10 are only for CP-132EL Series and CP-114EL Series>
After rebooting, key in “moxaadm”. When you see MAIN MENU, select Interface
Configuration to set your Resister and Interface. For example, if you want to set one of the
CP-114EL ports as RS-422 and 120Ω, you have to select RS-422 and 120Ω.
10. Save your Interface Configuration and then reboot computer again.
11. Note that whenever you change a MAIN MENU item, you have to reboot your computer.