Installation guide

— 5 —
To Install
STEP 1:
Use the recessed button on the
spring-loaded bracket to lock it into
position.
STEP 2:
Insert the top of the DIN-Rail into
the slot just below the upper hook of
the DIN-Rail mounting kit. Push the
AWK-6222 toward the DIN-Rail
until the DIN-Rail attachment
bracket snaps into place.
To Release
STEP 1:
Pull out the two spring-loaded
brackets from the bottom until they
are fixed in the “release” position.
STEP 2:
Pull the AWK-6222 out and
upward.
Wiring Requirements
WARNING Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your Moxa AWK-6222.
Calculate the maximum possible current in each power wire and
common wire. Observe all electrical codes dictating the
maximum current allowable for each wire size. If the current goes
above the maximum ratings, the wiring could overheat, causing
serious damage to your equipment.