Installation guide

— 3 —
Dimensions (unit = mm)
in
in
in
in
in
Wall Mounting
In most applications, wall mount provides an easier installation. You will find
it quite easy to mount AWK-6222 on the wall, as illustrated below.
STEP 1:
Attach the wall-mounting kit with
M4 screws, as shown in the
diagram below.
STEP 2:
Mounting the AWK-6222 on the wall
requires 4 screws. Use the AWK-6222
device, with wall-mounting kit attached, as
a guide to mark the correct locations of the
4 screws. The heads of the screws should
be between 5.5mm and 8.5 mm in
diameter, and the shafts should not be
more than 5.0 mm in diameter, as shown
in the figure.
5.5 - 8.5 mm
< 5.0 mm
Do not screw the screws all the way in to the wall—leave a space of about 2
mm to allow room to slide the wall-mounting kit between the wall and the
screws.
ATTENTION
You can test the screw head and shank size by inserting the screw
into one of the keyhole shaped apertures of the wall mounting
plates before it is screwed into the wall.