Installation guide

— 10 —
STEP 3:
Crimp the modular RJ plug to the cable; (NOTE: the snagless cover shield and
strain-relief boot are not recommended.) Then, assemble the seals and the
housing (③ and ⑤).
STEP 4:
Tightly screw the clamp ring ④ to the housing and check to make sure that the
plug is securely fastened.
(NOTE: for a tighter connection, you can connect the RJ-45 plug to the
AWK-6222 before STEP 4.)
LED Indicators
The front panel of the Moxa AWK-6222 contains several LED indicators. The
function of each LED is described in the table below.
LED Color State Description
On
Power is being supplied (from power
input 1 or 2, or PoE)
PWR
Green
Off Power is not being supplied.
On Relay is event-triggered.
Blink (slow)
Cannot get an IP address from the
DHCP server (interval: 1 sec).
Blink (fast) IP address conflict (interval: 0.5 sec).
FAULT
Red
Off Normal status.
Green Software Ready.
Green Blink
The AWK Search Utility has located
the AWK. (interval: 1sec).
STATE
Green/Red
Red Booting or Error condition.
Green On
WLAN is functioning in
Client/Slave mode.
Green Blink
WLAN’s is transmitting data in
Client/Slave mode.
Amber On
WLAN is functioning in
AP/Bridge/Master mode.
Amber Blink
WLAN’s is transmitting data in
AP/Bridge/Master mode.
WLAN 1
Green/
Amber
Off
WLAN is not in use or not working
properly.