User Manual
- 12 -
Waterproofing the RJ45 Plug
Dimensions (unit: mm)
Installation
STEP 1:
Attach the gasket
① to the housing ③
STEP 2:
Insert the cable (e.g., CAT5e) through the clamp ring ④, screw nut ②,
seal ⑤ and housing ③, as follows:
STEP 3:
Crimp the modular RJ plug to the cable. Note that the use of a snagless
cover shield or a strain-relief boot is not recommended here. After you
have crimped the cable, assemble the seal and the housing (③ and ⑤) as
indicated below:
STEP 4:
Tightly screw
on the clamp ring ④ to
the housing and check to make sure
that the plug is securely fastened.
NOTE
For a tighter connection, you can connect the RJ45 plug to the
AWK-4131A before STEP 4.