Installation guide

- 9 -
Cable Holder Installation (Optional)
You can attach the cable holder to the bottom of the AWK-3121. This
helps to keep cabling neat and avoid accidents that result from untidy
cables.
STEP 1: Screw the cable holder onto the bottom
of the AWK
-3121.
STEP 2:
After mounting the AWK-3121 and plugging in the LAN cable,
tighten the cable along the device and wall.
Communication Connections
10/100BaseT(X) Ethernet Port Connection
The 10/100BaseT(X) ports located on the AWK-3121’s front panel are
used to connect to Ethernet-enabled devices.
Below we show pinouts for both MDI (NIC-type) ports and MDI-X
(HUB/Switch-type) ports.
MDI Port Pinouts MDI-X Port Pinouts 8-pin RJ45
Pin Signal Pin Signal
1 Tx+ 1 Rx+
2
Tx-
2
Rx-
3
Rx+
3
Tx+
6
Rx-
6
Tx-