User Manual

- 9 -

Installing Cable Extended Antennas for Outdoor Applications

If the antenna or the AWK device is installed outdoors or in an open-air

setting, proper lightning protection is required to prevent direct

lightning strikes on the AWK device. In order to prevent coupling

currents from nearby lightning strikes, a lightning arrester should be

installed as part of your antenna system. Ground the device, antenna,

as well as the arrester properly to provide maximum outdoor protection

for the device.

Arrester Accessories

• SA-NMNF-01: Surge arrester, N-type (male) to N-type (female)

• SA-NFNF-01: Surge arrester, N-type (female) to N-type (female)

Wiring the Power Input

The 3-contact terminal block connector on the AWK-1137C’s side panel

is used for the AWK-1137C’s DC input. The top and front views of the

terminal block connector are shown below:

STEP 1:

Insert the negative/positive DC wires into the

-/V+ terminals.

STEP 2:

To keep the DC wires from pulling

loose, use a

small flat

-blade screwdriver to tighten the wire-

clamp screws on

the front of the terminal block

connector.

STEP 3:

Insert the plastic terminal block connector

prongs into the terminal block receptor, which

located on the AWK-1137C’s side panel.