User Manual

- 6 -
To remove the AWK-1137C from the DIN rail, do the following:
STEP 1:
Pull down the latch on the DIN
-
rail kit with a screwdriver.
STEP 2 & 3:
Slightly pull the
AWK
-1137C forward and lift it
up to remove it from the
mounting rail.
Wall Mounting (Optional)
For some applications, it may be more convenient to mount the AWK-
1137C to a wall, as illustrated below:
STEP 1:
Remove the aluminum
DIN
-rail attachment
plate from the
AWK-
1137C, and then attach
the wall
-mounting
plates with M3 screws,
as shown in the
adja
cent diagrams.
STEP 2:
Mounting the
AWK-1137C to a wall requires two
screws. Use
the AWK-1137C device, with wall-
mount
ing plates attached, as a guide to mark the
correct locations of the
two screws. The heads of the
screws should be less than 6.0 mm in diameter, and
the
shafts should be less than 3.5 mm in diameter,
as shown in the figure on the right.
Do not drive the screws in all the way—leave a space of about 2 mm to
allow room for sliding the wall-mounting panel between the wall and
the screws.
NOTE
Test the screw head and shank size by inserting the screws into
one of the keyhole
-shaped apertures of the wall-mounting
plates before they are fixed to the wall.