User Manual

- 13 -
ATTENTION
Do not locate the antenna near overhead power lines or other
electric light or power circuits, or where it can come into
contact with such circuits. When installing the antenna, take
extreme care not to come into contact with such circuits,
because they may cause serious injury or death. For proper
installation and grounding of the antenna, refer to national and
local co
des (for example, U.S.: NFPA 70; National Electrical
Code (NEC) Ar
ticle 810; Canada: Canadian Electrical Code,
Section 54).
WARNING
Este equipamento não tem direito à proteção contra
interferência prejudicial e não pode causar interferência em
sistemas devidamente autorizados.
This
equipment has no right to protection against harmful
interference and cannot cause interference in duly authorized
systems.
NOTE
For installation flexibility, you may select either antenna A or
antenna
B on the top panel. Make sure the antenna connection
matches the antenna
s configured in the AWK-1137C web
interface.
To protect the connectors and RF module, all radio ports should
be terminated by either an antenna or a terminator.
We
strongly recommend using resistive terminators for terminating
the unused antenna ports.
Federal Communications Commission
Interference Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.