User Manual

- 10 -
NOTE
Input Terminal Block (CN1) is suitable for wire size range of 12-
28 AWG (3.31
-0.0804 mm²) and a torque value of 4.5 lb-in
(0.51 Nm)
ATTENTION
If the
AWK-1137C
is connected to a motor or other similar type
of equipment, be sure to use power isolation protection. Before
connecting the
AWK-1137C
to the DC power inputs, make sure
the DC power source voltage is stable.
Using the Reset Button
The Reset button is used to load the factory default settings. Use a
pointed object to hold the Reset button down for five seconds to load
the factory defaults.
Activating AeroMag Function
Push the Reset Button five times to activate AeroMag. To deactivate it
again, push the Reset Button three times.
Installing the Antenna-Locking Clamp
Use the antenna-locking clamp to secure the antennas to the AWK-
1137C for added stability when you install the device in a high-vibration
environment.
STEP 1:
Slide the
locking clamps through
the
antenna ports.
STEP 2:
Use s
crews to fix the clamps to the
side
panel of the AWK-1137C as
shown below:
Communication Connections
10/100BaseT(X) Ethernet Port Connection
The 10/100BaseT(X) ports located on the AWK-1137C’s front panel are
used to connect to Ethernet-enabled devices.