User Manual

- 7 -
STEP 3a:
Once the screws are fixed into the
wall, insert the
two screw heads
through the large opening of the
keyhole
-shaped apertures, and then
slide the
AWK-1137C downwards, as
indicated to the right. Tighten the
two
screws for added stability.
STEP 3b:
Alternatively, insert four screws
directly through the AWK
-1137C into
the wall.
WARNING
•
This equipment is intended to be used in a Restricted
Access Location, such as a dedicated computer room
where
only authorized service personnel or
users can gain access.
Such personnel must be instructed about the fact that the
metal chassis of the equipment is extremely hot and may
cause burns.
•
Service personnel or users have to pay special attention
and take special precautions before handling this
equipment.
•
Only authorized, well-trained professionals should be
allowed to access the Restricted Access Location. Access
should be controlled by the authority responsible for the
location with a lock and key or a security identity system.
•
External metal parts are hot!! Pay special attention or
use special protection before handling this equipment.
Wiring Requirements
WARNING
Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your M
oxa AWK-1137C.
Calculate the maximum possible current in each power wire
and common wire. Observe all electrical codes that dictate the
maximum current allowed for each wire size. If the current
goes above the maximum ratings, the wiring could overheat,
causing serious damage to your equipment.