Datasheet

www.moxa.com
2
5.260 to 5.320 GHz (4 channels)
2
5.500 to 5.700 GHz (11 channels)
2
5.745 to 5.825 GHz (5 channels)
Frequency Band for EU (20 MHz operating channels) 2.412 to 2.472 GHz (13 channels)
5.180 to 5.240 GHz (4 channels)
5.260 to 5.320 GHz (4 channels)
2
5.500 to 5.700 GHz (11 channels)
2
Frequency Band for JP (20 MHz operating channels) 2.412 to 2.484 GHz (14 channels)
5.180 to 5.240 GHz (4 channels)
5.260 to 5.320 GHz (4 channels)
2
5.500 to 5.700 GHz (11 channels)
2
Wireless Security WEP encryption (64-bit and 128-bit)
WPA/WPA2-Enterprise (IEEE 802.1X/RADIUS, TKIP, AES)
WPA/WPA2-Personal
Transmission Rate 802.11b: 1 to 11 Mbps
802.11a/g: 6 to 54 Mbps
802.11n: 6.5 to 300 Mbps
Transmitter Power for 802.11a 23±1.5 dBm @ 6 to 24 Mbps
21±1.5 dBm @ 36 Mbps
20±1.5 dBm @ 48 Mbps
18±1.5 dBm @ 54 Mbps
Transmitter Power for 802.11n (5 GHz) 23±1.5 dBm @ MCS0/8 20 MHz
18±1.5 dBm @ MCS7/15 20 MHz
23±1.5 dBm @ MCS0/8 40 MHz
18±1.5 dBm @ MCS7/15 40 MHz
Transmitter Power for 802.11b 26±1.5 dBm @ 1 Mbps
26±1.5 dBm @ 2 Mbps
26±1.5 dBm @ 5.5 Mbps
25±1.5 dBm @ 11 Mbps
Transmitter Power for 802.11g 23±1.5 dBm @ 6 to 24 Mbps
22±1.5 dBm @ 36 Mbps
20±1.5 dBm @ 48 Mbps
19±1.5 dBm @ 54 Mbps
Transmitter Power for 802.11n (2.4 GHz) 23±1.5 dBm @ MCS0/8 20 MHz
17±1.5 dBm @ MCS7/15 20 MHz
23±1.5 dBm @ MCS0/8 40 MHz
17±1.5 dBm @ MCS7/15 40 MHz
Transmitter Power
US EU JP
2.4 GHz 26 dBm 18 dBm 18 dBm
5 GHz (UNII-1) 23 dBm 23 dBm 23 dBm
5 GHz (UNII-2) 23 dBm 23 dBm 23 dBm
5 GHz (UNII-2e) 23 dBm 23 dBm 23 dBm
5 GHz (UNII-3) 23 dBm – –
Note: Based on regional regulations, the maximum transmission power allowed on
the UNII bands is restricted in the firmware, as indicated above.
Receiver Sensitivity for 802.11a (measured at 5.680
GHz)
Typ. -90 @ 6 Mbps
Typ. -88 @ 9 Mbps
Typ. -87 @ 12 Mbps
Typ. -85 @ 18 Mbps
Typ. -81 @ 24 Mbps
Typ. -78 @ 36 Mbps
2. DFS (Dynamic Frequency Selection) channel support: In AP mode, when a radar signal is detected, the device will automatically switch to another channel.
However, according to regulations, after switching channels, a 60-second availability check period is required before starting the service.