User Manual

- 6 -
To remove the AWK-1131A from the DIN rail, do the following:
STEP 1:
Pull down the latch on the DIN
-
rail
kit with a screwdriver.
STEP 2 & 3
:
Slightly pull the AWK
-1131A
forward and lift it up to remove it
from the mounting rail.
Wall Mounting (optional)
For some applications, it may be more convenient to mount the
AWK-1131A to a wall, as illustrated below.
STEP 1:
Remove the
aluminum
DIN
-rail attachment plate
from the AWK
-1131A, and
then attach the wall mount
plates with M
3 screws, as
shown in the adjacent
diagrams.
STEP 2:
Mounting the AWK
-1131A to a wall requires 4 screws.
Use the AWK
-1131A device, with wall mount plates
attached, as a guide to mark the correct locations of the
4 screws. The heads of the screws should be less than 6.0
mm in diameter, and the
shafts should be less than 3.5
mm in diameter, as shown in the figure at the right.
Do not drive the screws in all the way—leave a space of about 2 mm to
allow room for sliding the wall mount panel between the wall and the
screws.
NOTE
Test the screw head and shank size by inserting the screws into
one of the k
eyhole shaped apertures of the wall-mounting p
lates
before attaching the plate to the wall.
STEP 3:
Once the screws are fixed into
the wall, insert the four screw
heads through the large opening
of the keyhole
-shaped
apertures, and then slide the
AWK
-1131A downwards, as
indicated to the right. Tighten
the
four screws for added
stability.