User`s manual

AWK-1121/1127 Web Console Configuration
3-48
Save Configuration
The following figure shows how the AWK-1121/1127 stores the setting changes into volatile and non-volatile
memory. All data stored in volatile memory will disappear when the AWK-1121/1127 is shutdown or rebooted
unless they are saved in non-volatile memory. Because the AWK-1121/1127 starts up and initializes with the
settings stored in flash memory, all new changes must be saved to flash memory before restarting the
AWK-1121/1127.
This also means that new changes will not take effect unless you press the "Save and Restart" button.
After you click on Save Configuration in the left menu box, the following screen will appear. Click Save if you
wish to update the configuration settings in the flash memory at this time. Alternatively, you may choose to run
other functions and put off saving the configuration until later. However, the new setting changes will remain
in the non-volatile memory until you save the configurations.
Restart
If you submitted configuration changes, you will find a blinking string in the upper right corner of the screen.
After making all your changes, click the Restart function in the left menu box. One of two different screens will
appear.
If you made changes recently but did not save, you will be given two options. Clicking the Restart button here
will reboot the AWK-1121/1127 directly, and all setting changes will be ignored. Clicking the Save and
Restart button will apply all setting changes and then reboot the AWK-1121/1127.
If you run the Restart function without changing any configurations or saving all your changes, you will see
just one Restart button on your screen.