User`s manual

AWK-1121/1127 Web Console Configuration
3-40
System-related events Event is triggered when…
System restart (warm start) The AWK-1121/1127 is rebooted, such as when its settings are
changed (IP address, subnet mask, etc.).
Network-related events Event is triggered when…
LAN link on The LAN port is connected to a device or network.
LAN link off The port is disconnected (e.g., the cable is pulled out, or the
opposing device shuts down).
WLAN connected to AP The AWK-1121/1127 is associated with an AP.
WLAN disconnected The AWK-1121/1127 is disassociated from an AP.
Config-related events Event is triggered when…
Configuration Changed A configuration item has been changed.
Configuration file import via Web Console
The configuration file is imported to the AWK-1121/1127.
Console authentication failure An incorrect password is entered.
Firmware upgraded The AWK-1121/1127’s firmware is updated.
Power events Event is triggered when…
Power 1/2 transition (On -> Off) The AWK-1121/1127 is powered down in PWR1/2.
PoE transition (On -> Off) The AWK-1121/1127 is powered down in PoE (PoE model only).
Power 1/2 transition (Off -> On) The AWK-1121/1127 is powered via PWR1/2.
PoE transition (Off -> On) The AWK-1121/1127 is powered via PoE (PoE model only).
Syslog
This function provides the event logs for the Syslog server. The function supports up to three configurable
Syslog servers and Syslog server UDP port numbers. When an event occurs, the event will be sent as a Syslog
UDP packet to the specified Syslog servers.
Syslog Event Types
Detailed information for grouped events is shown in the following table. You can check the box for “Enable Log”
to enable groups of events. All values are enabled (checked) by default. Details for each event group can be
found on the table “System Log Event Types”, just above, on page 3-40.
Syslog Server Settings
You can configure the parameters for your Syslog servers in this page.