User`s manual

AWK-1121/1127 Web Console Configuration
3-36
Destination Address 1 to 4
Setting Description Factory Default
IP address range and
port (e.g.,
“192.168.1.1” to
“192.168.1.64” and
“4001”)
In UDP mode, you may specify up to 4 ranges
of IP addresses
for the serial port to connect to. At least one destination range
must be provided.
The maximum selectable IP address range is 64 addresses.
However, you can enter multicast addresses in the Begin field,
in the form xxx.xxx.xxx.255. For example, enter
“192.127.168.255” to allow the AWK-1127 to broadcast UDP
packets.
Begin: Empty
End: Empty
Port: 4001
Local Listen Port
Setting Description Factory Default
0 to 9999 This field specifies the UDP port that the AWK-1127 listens to
and that other devices must use to contact the attached serial
device.
4001
Packet Length
Setting Description Factory Default
0 to 1024 This field specifies the maximum amount of data that is allowed
to accumulate in the serial port buffer before sending.
0: Packet length is disregarded and data in the buffer will be
sent as specified by the delimiter settings or when the buffer is
full.
1 to 1024: Data in the buffer will be sent as soon it reaches the
specified length.
0
Delimiter 1 and 2
Setting Description Factory Default
Enable When these fields are enabled, serial data will accumulate in
the serial port’s buffer until the buffer is full or until the
specified delimiter character(s) are received. For example, the
carriage return character could be used as a delimiter in order
to transmit each sentence or paragraph in a separate packet.
Data will be packed according to Delimiter process.
Delimiters must be incorporated into the data stream at the
software or device level.
The Delimiter value can be set ranging
from 00 to FF.
Unchecked
ATTENTION
When
Delimiter 1 is enabled, Packet length must be set to 0.
Delimiter Process
This field specifies how data is packed when delimiter characters are received. This field has no effect if
Delimiter 1 is not enabled.
Setting Description Factory Default
Do Nothing Data accumulated in the serial port’s buffer will be packed,
including delimiters.
Do Nothing