Installation Guide

- 4 -
Installing the AIG-100
The AIG-100 can be mounted on to a DIN rail or on to a wall. The DIN-
rail mounting kit is attached by default. To order a wall-mounting kit,
contact a Moxa sales representative.
DIN-rail Mounting
To mount the AIG-100 on to a DIN rail, do the following:
1. Pull down the slider of the DIN-rail bracket at the back of the unit
2. Insert the top of the DIN rail into the slot just below the upper
hook of the DIN-rail bracket.
3. Latch the unit firmly on to the DIN rail as shown in the illustrations
below.
4. Once the computer is mounted properly, you will hear a click and
the slider will rebound back into place automatically.
Wall Mounting (optional)
The AIG-100 can also be wall mounted. The wall-mounting kit needs to
be purchased separately. Refer to the datasheet for more information.
1. Fasten the wall-mounting kit to the AIG-100 as shown below:
2. Use two screws to mount the AIG-100 on to a wall.
These two screws are not included in the wall-mounting kit and