Installation Guide

- 3 -
AIG-101-T-AP/EU/US
LED Indicators
LED Name
Status
Function
SYS
Green
Power is ON
Off
Power is OFF
Green
(blinking)
The gateway will reset to the default
configuration
LAN1/LAN2
Green
10/100 Mbps Ethernet mode
Off
Ethernet port is not active
COM1/COM2
Orange
Serial port is transmitting or receiving data
LTE
Green
Cellular connection has been established
NOTE:
Three levels based on the signal strength
1 LED is ON: Poor signal quality
2 LEDs are ON: Good signal quality
All 3 LEDs are ON: Excellent signal quality
Off
Cellular interface is not active
Reset Button
Reboots or restores the AIG-100 to factory default settings. Use a
pointed object, such as a straightened paper clip, to activate this
button.
• System reboot: Press and hold the Reset button for one second or
less.
• Reset to the default configuration: Press and hold the Reset button
till the SYS LED blinks (approximately seven seconds).