User`s manual

WE-2100T Series User’s Manual Web Console: Serial Port Settings
8-12
Destination Address 1 to 4
Default
Options
IP address and port (e.g., “192.168.1.1” and “4001”)
Description
This field specifies the remote host(s) that will access the attached device. At
least one destination must be provided. This field supports the use of domain
names and names defined in the host table.
ATTENTION
In TCP Client mode, up to 4 connections can be established between the serial port and TCP
hosts. The connection speed or throughput may be low if any one of the four connections is slow,
since the one slow connection will slow down the other 3 connections.
Connection Control
Default
Startup
Options
Startup, Any Character
Description
This field specifies how connections to the device are established and closed.
Startup: The connection will be opened as the module starts up.
Any Character: The connection will be opened as soon as a character is received
from the attached device.
Delimiter 1 and 2
Default
Disabled
Options
Disabled, Enabled, 00 to FF
Description
These fields are used to define special delimiter character(s) for data packing.
Enable Delimiter 1 to control data packing with a single character; enable both
Delimiter 1 and 2 to control data packing with two characters received in
sequence.
When these fields are enabled, serial data will accumulate in the serial port’s
buffer until the buffer is full or until the specified delimiter character(s) are
received. For example, the carriage return character could be used as a delimiter
in order to transmit each sentence or paragraph in a separate packet.
Delimiters must be incorporated into the data stream at the software or device
level.