User`s manual

WE-2100T Series User’s Manual Web Console: Network Settings
7-22
Auto Report Period
Default
10
Options
0 to 99
Description
This field specifies how often the WE-2100T sends IP address reports.
Active Interface
Default
Auto Detect
Options
Auto Detect, Select by DI8, Force Wired Ethernet, Force Wireless LAN
Description
This field specifies how the WE-2100T will select whether to use the wired
LAN connection or the wireless (WLAN) connection.
Auto Detect: The LAN connection will be used if a valid connection is detected
when the module is powered on. Otherwise, the module will use the WLAN
connection.
Select by DI8: The network connection will be determined by the signal from
DIO channel 8. This channel must be set to DI mode. When the signal is low,
the module will use the LAN connection. When the signal is high, the module
will use the WLAN connection.
Force Wired Ethernet: The module will only use the LAN connection. The
WLAN connection will be ignored.
Force Wireless LAN: The module will only use the WLAN connection. The
LAN connection will be ignored.