User`s manual

WE-2100T Series User’s Manual Web Console: Basic Settings
6-3
Navigating the Web Console
To open the web console, enter your module’s IP address in the website address line. If you are
configuring the unit for the first time over an Ethernet cable, you will use the default LAN IP
address, 192.168.126.254. Please refer to Chapter 5 for instructions on assigning the IP address.
If prompted, enter the console password. You will only be prompted for a password if you have
enabled password protection on the module. The password will be transmitted with MD5
encryption over the Ethernet.
ATTENTION
If you have forgotten the password, you can use the reset button to load factory defaults. This will
erase all previous configuration information.
The web console will appear as shown below.
Settings are presented on pages that are organized by folder. Pages are selected in the left
navigation panel. For example, if you click Basic Settings in the navigation panel, the main
window will show a page of basic settings that you can configure. Certain folders can be expanded
by clicking the adjacent “+” symbol.
After you have made changes on a page, you must click Submit in the main window before
jumping to another page. Your changes will be lost if you do not click Submit.
After you have finished modifying the desired pages, you must save and restart the module for the
new settings to take effect. You may complete this in one step by clicking Save/Restart after you
submit a change. Changes will not take effect until they are saved and the unit is restarted. If you
restart the module without saving your configuration, all configuration changes will be lost.
ATTENTION
You may use Network Enabler Administrator to export the configuration file when you have
finished configuring the module. This way, you can restore your settings if you need to reset the
module. Please refer to Chapter 12 for additional information about using the Export and Import
functions.