User`s manual

WE-2100T Series User’s Manual Initial IP Address Configuration
5-7
3. In your terminal emulator program, configure the communication parameters for the serial
port on the PC. The parameters should be set to 19200 for baud rate, 8 for data bits, None for
parity, and 1 for stop bits.
4. In your terminal emulator program, set the terminal type to ANSI or VT100. If you select
Dumb Terminal as the terminal type, some of the console functions may not work properly.
5. After setting the terminal options, enter any character. The serial console will open and will
be functionally identical to the Telnet console. Please refer to the Telnet console section for
instructions on how to navigate the console and configure the IP settings.