User`s manual

WE-2100T Series User’s Manual Using Network Enabler Administrator
12-19
IP Address Report
The IP Address Report function is used to receive automatic IP reports from appropriately
configured WE-2100T modules. The IP Address Report context menu is shown below:
To configure a module to send IP address reports, enter the destination IP address in the Auto
report to parameter. On the web console, this parameter is on the Advanced Settings page in the
the Network Settings folder. The destination IP address should be the address of the PC that is
running Network Enabler Administrator.
Please refer to Chapter 7 for information on configuring the module to send automatic IP reports.
Please refer to Appendix E for information on the IP report protocol.
Settings
Description
This designates the TCP port number that the module is using to send IP address
reports. This must correspond with the settings on the module.