User`s manual

WE-2100T Series User’s Manual Using Network Enabler Administrator
12-16
COM Settings
Description
This specifies which COM port will be mapped to the selected serial port, along
with other settings.
ATTENTION
You can map multiple COM ports in one step by holding down the CTRL or SHIFT key when
selecting the target serial ports.
Basic Settings
In the Basic Settings tab, the COM Number parameter selects the COM port that will be mapped
to the device port. The drop-down list shows available COM ports with status.
Status Description
in use
The COM number is already being used by the system or being mapped to a
module.
assigned
The COM number has been tentatively mapped to one of the serial ports on
the COM Mapping list.
current + in use
The COM number is currently being mapped by the Real COM driver to the
selected serial port.
current + assigned
The COM number has been tentatively mapped to the selected serial port, but
the Real COM driver has not been updated yet.
The “Auto Enumerating” parameter can be used when mapping multiple COM ports at the same
time. When the parameter is checked, this option automatically assigns available COM numbers
sequentially. If not checked, you will need to assign each COM number separately.