User`s manual

WE-2100T Series User’s Manual Using Network Enabler Administrator
12-15
Add Target
Description
This places modules on the module list for COM mapping. You may need to
click Rescan to search the network for available modules. You can also select
Input manually to enter a specific IP address and model.
Each item on the COM Mapping list refers to a single serial port on a
WE-2100T module.
Remove Target
Description
This removes an item from the COM Mapping list.
ATTENTION
You can configure COM mapping even if your module is off-line (not connected). When using
the Add Target command, simply select the “Input manually” option and enter the IP address and
model. This is a useful option for certain field installations where COM mapping must be set up
before the module is physically installed.