User`s manual

WE-2100T Series User’s Manual Using Network Enabler Administrator
12-11
Remove Target
Description
This removes a module from the Monitor list.
Load Configured COM Port
Description
If any COM ports are being mapped to modules over the network, this
command will add those modules to the Monitor list. (COM ports can be
mapped over the network to a serial port on the WE-2100T that is operating in
RealCOM mode.)
Settings
Description
This specifies which items of information will be monitored, how often the
information is refreshed, and how notification of events will occur.
The Monitor Items tab is where you select the items to be monitored.
The General Settings tab is where you specify how often the status of each
module will be checked. The default is 3 seconds.
The Advanced Settings tab is where you specify alarm behavior. The alarm
notifies you if a connection is off-line. You may choose an audio alarm as well
as a pop-up warning message.