User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- Powering on the W406-LX
- Connecting the W406-LX to a PC
- Configuring the Ethernet Interface
- USB Port for Expansion
- SD Socket for Storage Expansion
- Setting Up the Wireless Module
- Configuring the SIM Card
- Entering the PIN Code
- Verifying the SIM Card Status
- Enabling or Disabling the PIN Code Authentication
- Changing the PIN Code
- Unlocking the SIM Card
- Connecting to the Internet
- Reconnecting to the Internet
- Disconnecting from the Internet
- Detecting an Internet Connection Error
- Sending and Reading an SMS Message
- Deleting an SMS Message
- Test Program—Developing Hello.c
- 3. Managing Embedded Linux
- 4. Managing Communications
- 5. Development Tool Chains
- 6. Programmer’s Guide
- 7. Software Lock
- A. System Commands
W406-LX User’s Manual Managing Communications
4-25
Interface eth1 is connected to the bridging interface br0, to which device tap0 also connects,
whereas the virtual device tun sits on top of tap0. This ensures that all traffic from internal
networks connected to interface eth1 that come to this bridge write to the TAP/TUN device
that the OpenVPN program monitors. Once the OpenVPN program detects traffic on the
virtual device, it sends the traffic to its peer.
6. To create an indirect connection to Host B from Host A, you need to add the following routing
item:
route add –net 192.168.4.0 netmask 255.255.255.0 dev eth0
To create an indirect connection to Host A from Host B, you need to add the following routing
item:
route add –net 192.168.2.0 netmask 255.255.255.0 dev eth0
Now ping Host B from Host A by typing:
ping 192.168.4.174
A successful ping indicates that you have created a VPN system that only allows authorized
users from one internal network to access users at the remote site. For this system, all data is
transmitted by UDP packets on port 5000 between OpenVPN peers.
7. To shut down OpenVPN programs, type the command:
# killall -TERM openvpn
Setup 2: Ethernet Bridging for Private Networks on the Same Subnet
1. Set up four machines as shown in the following diagram:
2. The configuration procedure is almost the same as for the previous example. The only
difference is that you will need to indicate the #up parameter.
“/etc/openvpn/A-tap0-br.conf” and “/etc/openvpn/B-tap0-br.conf”.