User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- Powering on the W406-LX
- Connecting the W406-LX to a PC
- Configuring the Ethernet Interface
- USB Port for Expansion
- SD Socket for Storage Expansion
- Setting Up the Wireless Module
- Configuring the SIM Card
- Entering the PIN Code
- Verifying the SIM Card Status
- Enabling or Disabling the PIN Code Authentication
- Changing the PIN Code
- Unlocking the SIM Card
- Connecting to the Internet
- Reconnecting to the Internet
- Disconnecting from the Internet
- Detecting an Internet Connection Error
- Sending and Reading an SMS Message
- Deleting an SMS Message
- Test Program—Developing Hello.c
- 3. Managing Embedded Linux
- 4. Managing Communications
- 5. Development Tool Chains
- 6. Programmer’s Guide
- 7. Software Lock
- A. System Commands
W406-LX User’s Manual Managing Embedded Linux
3-4
150 Opening data connection for W406-x.x.x.hfm
226 Transfer complete.
13167772 bytes received in 2.17 secs (5925.8 kB/s)
ftp>
3. Next, use the upgradehfm command to upgrade the kernel and root file system:
#upgradehfm W406-x.x.x.hfm
192.168.3.127 – PuTTY
root@Moxa:/mnt/ramdisk# upgradehfm W406-x.x.x.hfm
Moxa W406 upgrade firmware utility version 1.0.
To check source firmware file context.
The source firmware file context is OK.
This step will destroy all your firmware.
Continue ? (Y/N) : Y
Now upgrade the file [kernel].
Format MTD device [/dev/mtd1] . . .
MTD device [/dev/mtd1] erase 128 Kibyte @ 1C0000 – 100% complete.
Wait to write file . . .
Compleleted 100%
Now upgrade the file [usrdisk].
Format MTD device [/dev/mtd2] . . .
MTD device [/dev/mtd2] erase 128 Kibyte @ 800000 – 100% complete.
Wait to write file . . .
Compleleted 100%
Upgrade the firmware is OK.
ATTENTION
The upgradehfm utility will reboot your target after the upgrade is OK.
Loading Factory Defaults
To load the factory default settings, you must press the reset-to-default button for more than 5
seconds. All files in the /home & /etc directories will be deleted. Note that while pressing the
reset-to-default button, the Ready LED will blink once every second for the first 5 seconds. The
Ready LED will turn off after 5 seconds, and the factory defaults will be loaded.
Enabling and Disabling Daemons
The following daemons are enabled when the W406-LX boots up for the first time.
snmpd ..........SNMP Agent daemon
telnetd..........Telnet Server daemon and Client
inetd.............Internet Daemons
ftpd...............FTP Server daemon and Client
sshd ..............Secure Shell Server daemon
httpd ............Apache WWW Server daemon