User`s manual

VPort P06-1MP-M12 EN 50155 IP Camera Getting Started
2-7
VPort P06-1MP-M12 Dimensions
Front View Bottom View
Top View Camera with SC01 adaptor
(Unit = mm)
Wiring Requirements
ATTENTION
•
Be sure to disconnect the power cord before installing and/or wiring your Moxa VPort P06-1MP-M12.
•
Calculate the maximum possible current in each power wire and common wire. Observe all electrical codes
dictating the maximum current allowable for each wire size.
•
I
f the current goes above the maximum ratings, the wiring could overheat, causing serious damage to your
equipment.
You should also pay attention to the following:
• Use separate paths to route wiring for power and devices. If power wiring and device wiring paths must
cross make sure the wires are perpendicular at the intersection point.
NOTE: Do not run signal or communications wiring and power wiring in the same wire conduit. To avoid
interference, wires with different signal characteristics should be routed separately.