User`s manual

VPort 36-1MP System Configuration
4-30
Digital PTZ
Before use digital PTZ, you need to enable digital PTZ function in VPort 36-1MP setting page as shown below.
First check enable, then choose the PTZ function you are like to operate. Note that digital zoom and digital
pan/tilt functions could be enabled separately.
Press save when you done digital PTZ settings.
NOTE
When work VPort 36
-1MP with PT scanner, digital Pan/Tilt function will be disabled automatically. This is to
allow PT scanner to perform Pan/Tilt function without interference from digital Pa
n/Tilt function.
Once Digital PTZ function is enabled, you can then go to IP camera home page and call out PTZ control panel
to perform digital PTZ functions.
Below is the PTZ control panel you will see when you click “Show PTZ Control Panel” in IP camera home page.
You can press “+” button in the bottom right of the page to perform digital zoom function. After digital zoom,
you can then navigate the camera image by press direction button in the wheel.