User`s manual

VPort 36-1MP System Configuration
4-25
Image Adjustment
Setting Description Default
Saturation Tune the image attribute for the user’s preference for -4 to +6 0
Contrast & Sharpness Tune the image attribute for the user’s preference for -4 to + 4 0
Auto Gain Control
(AGC)
This AGC function provides clear image in low light condition.
This controls an amplifier that is used to boost the video signal
when the light dims so as to increase the camera’s
sensitivity.
In some bright environment, the amplifier may be overloaded
and which may distort the video signal. So, it is necessary to
monitor the signal level with AGC control circuit and AGC has to
be switched off in case of necessity.
16x
Back light control (BLC) This function is to correct the exposure of subjects that are in
front of a bright light source.
Off
AWB
(Auto White Balance)
In most condition, you are suggested to choose ATW and allows
the camera to do automatic white balance adjustment. A
WB is
suggested when your camera is watching a scene with a certain
color occupy most for the view.
If you like to use AWB, follow below step.
Step 1:
Move the camera to the white color in the real environment
with normal lighting
Step 2:
Select AWB in the page and then press “Save”
Step 3:
Move the camera back to the scene you are going to watch
ATW
Appearance Normal – Normal view
Mirror – Image will be displayed as in a mirror
Flip – First 180 degree rotation and then do mirrored display
180 Rotation – Display image after 180 degree rotation
Normal
Digital Noise Reduction
Setting Description Default
Enable Enable digital noise reduction function Off
Day / Night
Setting Description Default
Day Manually set the camera to day mode (color mode) checked
Night
Manually set the camera to night mode (monochrome mode)
Unchecked
Light Sensor Let camera light sensor to switch day/night mode based on
ambient illumination level.
Set duration sec to define how long should the illumination level
persist before day/ngith swtich
Unchecked
DI Control Switch day/night when by DI
• High Low Switch: camera will do day/night switch whenever
DI status change
• Pull High: camera will do day/night switch whenever DI
status is high
• Pull Low: camera will do day/night switch whenever DI
status is low
unchecked
Trigger relay output
when day/night mode
switch
Trigger relay output when day/night mode switch, relay status
for day/night mode could be configured separately
unchecked