User`s manual

VPort 36-1MP Getting Started

2-3

Step 3: Remove lens holder

NOTE

ake sure you loosen the screw fastening the lens holder before trying to remove the lens holder. The lens

holder may be too tight to loosen if pressi

ng screw is not loosened first

Step 4: Screw lens holder to the lens you are going to use.

NOTE

Observe carefully, make sure you screw lens holder to the lens

on the correct side. The side of the

lens holder

with

the groove should be facing the lens, the other side without a groove should be facing outward.

Step 5: Screw lens and lens holder to VPort 36-1MP

NOTE

You are suggested do this step while viewing the live video from the camera via web browser, so you can

identify

when to stop. Make sure you don’t screw all the way to the end

, or the lens holder may fix to the

camera when you remove the

lens.

NOTE

You can

use the lens holder pressing screw in step 2 to fix the position of lens holder and lens

. Again,

make sure you don’t screw the lens all the way down

otherwise ICR filter may be obstructed when

day/night switch

Step 6: Power on your VPort 36-1MP

NOTE

The

VPort 36-

1MP can be powered by 12 VDC / 24 VDC / 24 VAC input or Power over Ethernet (PoE, 802.3af).

You can

connect both to create redundant power input.

Groove