Installation guide

- 8 -

Step 3: Remove lens holder

NOTE

Make sure

to loosen the screw affixing the lens holder in step 2

before trying to remove

the lens holder. The l

ens holder may be

too tight to loosen if screw is not loosened first

Step 4: Screw lens holder to the lens you are going to use.

NOTE

Observe carefully, make sure you screw lens holder to the lens by

right side. The side of lens holder with groove should be facing

the lens, the other side without groove should be facing outward.

Step 5: Screw lens and lens holder to VPort 36-1MP

NOTE

You are suggested do this step while viewing live video from the

camera via web browser,

for instant feedback on when to stop.

Make sure you don’t screw all the way to the end, or the lens

holder may fix to the camera when you remove the lens.

NOTE

You can screw tight the lens holder pressing screw in step 2 to fix

the position of lens holder and lens

Step 6: Power on your VPort 36-1MP

NOTE

The

VPort 36-

1MP can be powered by 12 VDC / 24 VDC / 24 VAC

input or Power over Ethernet (PoE, 802.3af). You can install both

for a redundant power input.

Groove