Installation guide

- 11 -
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your
Moxa VPort 36-1MP.
Calculate the maximum possible current in each power wire and
common wire. Observe all electrical codes dictating the
maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could
overheat, causing serious damage to your equipment.
You should also pay attention to the following:
• Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
• You can use the type of signal transmitted through a wire to
determine which wires should be kept separate. The rule of thumb is
that wiring that shares similar electrical characteristics can be
bundled together.
• Keep input wiring and output wiring separated.
• It is strongly advised that you label wiring to all devices in the system
when necessary.
Specifications
Camera
Sensor
1/2.7” HD progressive scan CMOS
Lens
C/CS mount lens
Auto Iris Type
DC drive (lens not included when product delivery)
Illumination Color: 0.2 lux at F1.2
B/W: 0.05 lux at F1.2
Synchronizatio
n
Internal
White Balance
ATW/ AWB (rang 3200 ~ 10000 ºK)
Wide Dynamic
Color: 100 dB