Installation guide

— 16 —
On
RS-232 or RS-485 signals are
being transmitted
PTZ GREEN
Off
RS-232 or RS-485 signals are not
being transmitted or have not been
detected
Hardware Reset
A recessed RESET button is provided for restoring the system to the factory
default settings. When the system fails to install properly, or operates
abnormally, push the RESET button located on the top panel of the VPort 351
to restore the factory defaults.
To restore the VPort 351 to the factory default settings, use a pointed object,
such as a straightened paper clip or toothpick, to press the reset button
continuously. When the STAT LED blinks in red, release the reset button. At
this point, the POST process will run, and the VPort will reboot. The STAT
LED will light in green when the VPort has finished rebooting.
Specifications
Video
Video Compression MPEG4, MJPEG*
(*MJPEG will be supported after the release of
the V2.0 firmware)
Video Input 1, BNC Connector
Video Output 1, Loop-through BNC Connector
NTSC/PAL Auto-sensing or Manual
Video Resolution and FPS (Frames per second):
NTSC PAL
Size Max. FPS Size Max. FPS
QVGA
320 x 240
30
320 x 288
25
CIF
352 x 240
30
352 x 288
25
VGA
640 x 480
30
640 x 480
25
4CIF*
704 x 480
30
704 x 576
25
Full D1
720 x 480
30
720 x 576
25
* 4CIF will be supported after the release of the V2.0 firmware.
Video Viewing y Adjustable image size and quality
y Timestamp and text overlay
Audio
Audio Input 1 Line-in or MIC-in, 3.5 mm phone jack
Audio Output 1 Line-out, 3.5 mm phone jack
Network
Protocols TCP, UDP, HTTP, SMTP, FTP, Telnet, NTP,
DNS, DHCP, UPnP, RTP, RTSP, ICMP,
IGMPv3, SNMPv3*, PPPoE*, DDNS*
(SNMP, PPPoE, and DDNS will be supported
after the release of the V2.0 firmware)
Ethernet 1 10/100BaseT(X) auto negotiating RJ45 port, or
1 100BaseFX fiber port (SC connector)